Co-firing performance of pellets prepared from rice husk, rice straw, and lignite in a circulating fluidized bed combustor
Abstract
This study evaluates the co-firing performance of rice husk (RH) and rice straw (ST) pellets with and without 25% lignite addition in a 350 kWₜₕ circulating fluidized bed boiler. Four pellet formulations (RH100, RH75+CP25, ST100, and ST75+CP25) were investigated in terms of mechanical properties, thermal reactivity, and gaseous emissions. RH100 exhibited a higher vertical compressive strength than ST100 (21.55 vs 13.00 MPa), whereas ST100 showed higher abrasive resistance (98.02 vs 94.55%). The addition of 25% lignite caused modest reductions in compressive strength and abrasive resistance, while impact resistance remained high for all formulations (99.79-99.98%). Thermogravimetric analysis showed higher combustion reactivity for the pure biomass pellets than for the corresponding lignite-containing blends. Ignition temperatures increased from 221 to 245°C for the RH-based formulations and from 216 to 220°C for the ST-based formulations after lignite addition. ST100 exhibited the highest combustion indices, with Di = 0.044, S = 1.57 × 10⁻¹⁵, and C = 3.68 × 10⁻¹⁰. During CFBB combustion at 850±10°C, lignite addition increased CO concentrations from 1083.55 to 1803.96 mg/Nm³ for the RH-based fuels and from 1488.17 to 2832.42 mg/Nm³ for the ST-based fuels. SO₂ was not detected for the pure biomass pellets but reached 29.21 and 64.30 mg/Nm³ for RH75+CP25 and ST75+CP25, respectively, while NO emissions remained within 8.01–13.77 mg/Nm³. Overall, the results demonstrate a clear trade-off associated with 25% lignite incorporation: pellet mechanical integrity was largely retained, whereas combustion reactivity decreased and CO and SO₂ emissions increased. Among the tested formulations, the pure biomass pellets provided the most favorable overall balance of mechanical integrity, combustion reactivity, and gaseous emissions.
Keywords
Data Availability Statement
The data used to support the findings of this study are available from the corresponding author on reasonable request.
References
- Aich S, Nandi BK, 2025. Identification of combustion characteristics of high ash Indian coal, rice straw, rice straw char and their blends. Process Saf Environ Protect 193:1243-60.
- Baetge S, Kaltschmitt M, 2018. Rice straw and rice husks as energy sources - comparison of direct combustion and biogas production. Biomass Convers Bior 8:719-37.
- Basu P, 2010. Biomass gasification and pyrolysis: Practical design and theory. Cambridge, Academic Press.
- Beidaghy Dizaji H, Zeng T, Hartmann I, Enke D, Schliermann T, Lenz V, et al., 2019. Generation of high quality biogenic silica by combustion of rice husk and rice straw combined with pre- and post-treatment strategies - A review. Appl Sci 9:1083.
- Bennamoun L, Harun NY, Afzal MT, 2018. Effect of storage conditions on moisture sorption of mixed biomass pellets. Arab J Sci Eng 43:1195-203.
- Dao CN, Salam PA, Kim Oanh NT, Tabil LG, 2022. Effects of length-to-diameter ratio, pinewood sawdust, and sodium lignosulfonate on quality of rice straw pellets produced via a flat die pellet mill. Renew Energy 181:1140-54.
- Do TX, Tran KT, Vu AT, Van TDS, Le ST, Nguyen QT, 2025. Effects of pelletizing conditions and additives on properties of rice straw fuel pellets and ash characteristics. Biomass Convers Bior 15:16971-85.
- FAO, 2023. FAOSTAT statistical database: Crops and livestock products. Available from: https://www.fao.org/faostat/en/#data/QC
- Frodeson S, Henriksson G, Berghel J, 2019. Compression of biomass substances: A study on springback effects and color formation in pellet manufacture. Appl Sci 9:4302.
- Gadde B, Bonnet S, Menke C, Garivait S, 2009. Air pollutant emissions from rice straw open field burning in India, Thailand and the Philippines. Environ Pollut 157:1554-8.
- Gil MV, Oulego P, Casal MD, Pevida C, Pis JJ, Rubiera F, 2010. Mechanical durability and combustion characteristics of pellets from biomass blends. Bioresour Technol 101:8859-67.
- Guo F, He Y, Hassanpour A, Gardy J, Zhong Z, 2020. Thermogravimetric analysis on the co-combustion of biomass pellets with lignite and bituminous coal. Energy 197:117147.
- Jadwisieńczak K, Obidziński S, Choszcz D, 2023. Assessment of the physical and energetic properties of fuel pellets made from sage waste biomass with the addition of rye bran. Materials 16:58.
- Jaimes Rueda S, Rego de Vasconcelos B, Duret X, Lavoie JM, 2022. Lignin pellets for advanced thermochemical process - From a single pellet system to a laboratory-scale pellet mill. Energies 15:3007.
- Jenkins BM, Baxter LL, Miles Jr TR, Miles TR, 1998. Combustion properties of biomass. Fuel Process Technol 54:17-46.
- Kaniapan S, Pasupuleti J, Patma Nesan K, Abubackar HN, Umar HA, Oladosu TL, et al., 2022. A review of the sustainable utilization of rice residues for bioenergy conversion using different valorization techniques, their challenges, and techno-economic assessment. Int J Environ Res Public Health 19:3427.
- Kim SJ, Park SJ, Jo SH, Yoon SJ, Moon JH, Ra HW, et al., 2024. Low-NOx emission and amorphous siliceous ash production from rice husk combustion in circulating fluidized bed system. Fuel 374:132441.
- Kumar P, Nandi BK, 2022. Effect of rice husk blending on combustion characteristics of high ash Indian coal analyzed in TGA. Int J Coal Prep Util 42:3698-711.
- Lim JS, Manan ZA, Alwi SRW, Hashim H, 2012. A review on utilization of biomass from rice industry as a source of renewable energy. Renew Sust Energ Rev 16:3084-94.
- Liu M, Han B, Bai J, Ru J, Wang X, Xing L, et al., 2025. Investigation on the synergistic effects and thermokinetic analyses during co-combustion of corn stalk and polyethylene plastic: Effect of heating rate and placement method. Fuel 385:134032.
- Mansaray KG, Ghaly AE, 1997. Physical and thermochemical properties of rice husk. Energy Sources 19:989-1004.
- Mortadha H, Kerrouchi HB, Al-Othman A, Tawalbeh M, 2025. A comprehensive review of biomass pellets and their role in sustainable energy: Production, properties, environment, economics, and logistics. Waste Biomass Valoriz 16:4507-39.
- Ozyuguran A, Acma HH, Dahiloğlu E, 2017. Production of fuel briquettes from rice husk-lignite blends. Environ Prog Sustain Energy 36:742-8.
- Qin Z, Lei M, Zhang L, 2022. Thermogravimetric analysis of the co-combustion of bituminous coal, rice straw and sewage sludge. IOP Conf Ser Earth Environ Sci 1011:012028.
- Saidur R, Abdelaziz EA, Demirbas A, Hossain MS, Mekhilef S, 2011. A review on biomass as a fuel for boilers. Renew Sust Energ Rev 15:2262-89.
- Singh G, Gupta MK, Chaurasiya S, Sharma VS, Pimenov DY, 2021. Rice straw burning: a review on its global prevalence and the sustainable alternatives for its effective mitigation. Environ Sci Pollut Res 28:32125-55.
- Stasiak M, Molenda M, Bańda M, Horabik J, Wiącek J, Parafiniuk P, et al., 2020. Friction and shear properties of pine biomass and pellets. Materials 13:3567.
- Stolarski MJ, Stachowicz P, Dudziec P, 2022. Wood pellet quality depending on dendromass species. Renew Energy 199:498-508.
- Tumuluru JS, 2018. Effect of pellet die diameter on density and durability of pellets made from high moisture woody and herbaceous biomass. Carbon Resour Convers 1:44-54.
- Unchaisri T, Fukuda S, 2017. Co-firing of coal and rice straw pellet in a circulating fluidized-bed reactor. Energy Procedia 138:766-71.
- Unchaisri T, Fukuda S, 2022. Investigation of ash formation and deposit characteristics in CFB co-combustion of coal with various biomass fuels. J Energy Inst 105:42-52.
- Unchaisri T, Fukuda S, Phongphiphat A, Saetia S, Sajjakulnukit B, 2019. Experimental study on combustion characteristics in a CFB during co-firing of coal with biomass pellets in Thailand. Int Energy J 19:101-14.
- Vassilev SV, Baxter D, Andersen LK, Vassileva CG, 2010. An overview of the chemical composition of biomass. Fuel 89:913-33.
- Werther J, Saenger M, Hartge EU, Ogada T, Siagi Z, 2000. Combustion of agricultural residues. Prog Energy Combust Sci 26:1-27.
- Wnorowska J, Ciukaj S, Kalisz S, 2021. Thermogravimetric analysis of solid biofuels with additive under air atmosphere. Energies 14:2257.
- Zhang Y, Chen C, Qu B, Ji G, Li A, 2024. In-situ torrefaction-densification approach for pelletizing of rice hull/rice stalk and the combustion behavior analysis. Process Saf Environ Protect 183:365-77.
- Zulkornain MF, Rawian NAM, Neshaeimoghaddam H, Shamsuddin AH, Saad JM, Rahman AA, et al., 2022. Influence of organic binder and moisture content on the durability of rice husk and rice straw-based pellets. Int J Appl Sci Eng 19:2021235.
Metrics
Citations and online attention from Dimensions, Altmetric and PlumX.
License
Copyright (c) 2026 the Author(s)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
PAGEPress has chosen to apply the Creative Commons Attribution NonCommercial 4.0 International License (CC BY-NC 4.0) to all manuscripts to be published.